Vintage ribbed house slippers (1918)

Cosy slippers worked toe-first in back-loop single crochet ribs, with an elastic beading at the top and a looped ruching trim.

Vintage ribbed house slippers (1918): original photo from 1918
Original photo from Handbook of Wool Knitting and Crochet (Needlecraft Publishing Company, Augusta, Maine, 1918). Public domain.

About this pattern: this is a real pattern published in 1918. The text below is the original, word for word, with only the old stitch names changed to modern US terms (so a 1918 “double” reads as “sc”). We haven't changed any stitch counts. The untouched original is further down the page.

Materials and modern suggestions

These yarn and tool suggestions are ours, to help you choose modern materials.

Pattern (modern US terms)

Use 2-fold Shetland zephyr, or any similar yarn of moderate twist. Commencing at the toe, make a chain of 11 stitches, turn.

1. 1 sc in 2d stitch of chain and 1 in each of 8 stitches, 3 sc in end chain, 1 sc in each of 9 stitches down other side of chain, in same stitches where the 1st 9 sc were worked, chain 1, turn.

2. Ten sc in 10 sc, taking up back vein of stitch to form the rib, 3 sc in next, or center stitch, 10 sc in 10 sc, chain 1, turn.

3, 4, 5. Same as 2d row, making 1 extra sc each side of center, each row.

6. 1 sc in each sc, without widening, chain 1, turn.

7. 1 sc in each sc, with 3 in center stitch.

Repeat 6th and 7th rows until you have 25 ribs, or the vamp is as deep as desired. If preferred, the widening may be made every row, putting 2 sc in one and then the other, alternately, of the widening sc.

For the side of foot make 24 sc in 24 sc, chain 1, turn, 1 sc in sc, chain 1, turn, and continue until you have 44 ribs, or the strip is of sufficient length to extend easily around the sole; join neatly to 24 sc on opposite side of vamp.

Around top of slipper work a beading in which to run the elastic, thus: Fasten in, between 2 ribs, chain 10, * miss 5 ribs, 1 dtr (over 3 times) between next 2, chain 1, 1 dtr between next 2, chain 5, repeat from * around, ending with 1 dtr, chain 1, join to 5th of 10 chain.

For ruching: Have 3 strands of yarn, insert hook in work, over 4 times, pull through, and repeat in each stitch, pulling the loops out about three-fourths inch, and always taking yarn next to you to next stitch; make this for bottom of beading, as well, and the latter will be entirely covered. Run an elastic band or tape in the beading, between the 2 dtr, and make a bow of ribbon for instep of the same shade as the yarn.

Old crochet terms

Like many books of its time, this one uses the stitch names still used in the UK today. Here's what they mean in US terms:

In the 1918 bookModern US term
double (d c)single crochet (sc)
treble (t c)double crochet (dc)
half-treble or short-treblehalf double crochet (hdc)
double-treble (d t c)treble (tr)
triple-treble (t t c)double treble (dtr)
single crochet / slipslip stitch (sl st)
missskip
widen / wideningincrease
narrowdecrease
overyarn over
vein (of the stitch)loop: “back vein” is the back loop, “both veins” is both loops
needlehook
bone hooka hook made of bone; any hook of the same size works

1918 yarn names today

Approximate modern equivalents. Old yarns were often finer than today's, so knit or crochet a swatch first and compare it with any measurements the pattern gives.

1918 yarnClosest modern choice
Knitting-worstedworsted weight (#4)
Germantown wool or zephyr (fourfold)roughly worsted to aran weight (#4)
Saxonya fine yarn, roughly fingering to sport weight (#1–2)
Shetland flossa very fine, soft wool, roughly lace to light fingering weight (#0–1)
Angoraa fluffy angora yarn; any soft brushed yarn gives a similar effect
Original 1918 text (unchanged)

Use 2-fold Shetland zephyr, or any similar yarn of moderate twist. Commencing at the toe, make a chain of 11 stitches, turn.

1. A double in 2d stitch of chain and 1 in each of 8 stitches, 3 doubles in end chain, 1 double in each of 9 stitches down other side of chain, in same stitches where the 1st 9 doubles were worked, chain 1, turn.

2. Ten doubles in 10 doubles, taking up back vein of stitch to form the rib, 3 doubles in next, or center stitch, 10 doubles in 10 doubles, chain 1, turn.

3, 4, 5. Same as 2d row, making 1 extra double each side of center, each row.

6. A double in each double, without widening, chain 1, turn.

7. A double in each double, with 3 in center stitch.

Repeat 6th and 7th rows until you have 25 ribs, or the vamp is as deep as desired. If preferred, the widening may be made every row, putting 2 doubles in one and then the other, alternately, of the widening doubles.

For the side of foot make 24 doubles in 24 doubles, chain 1, turn, a double in double, chain 1, turn, and continue until you have 44 ribs, or the strip is of sufficient length to extend easily around the sole; join neatly to 24 doubles on opposite side of vamp.

Around top of slipper work a beading in which to run the elastic, thus: Fasten in, between 2 ribs, chain 10, * miss 5 ribs, a triple treble (over 3 times) between next 2, chain 1, a triple treble between next 2, chain 5, repeat from * around, ending with 1 triple treble, chain 1, join to 5th of 10 chain.

For ruching: Have 3 strands of yarn, insert hook in work, over 4 times, pull through, and repeat in each stitch, pulling the loops out about three-fourths inch, and always taking yarn next to you to next stitch; make this for bottom of beading, as well, and the latter will be entirely covered. Run an elastic band or tape in the beading, between the 2 triple trebles, and make a bow of ribbon for instep of the same shade as the yarn.

Source

Handbook of Wool Knitting and Crochet, Needlecraft Publishing Company, Augusta, Maine, 1918. This book is in the public domain in the United States. A digital edition is available free from Project Gutenberg.

More vintage crochet patterns

Looking for something new? Browse our free modern patterns, the crochet and knitting guides and the free yarn calculator.